General Pipe Cleaners Mini-Rooter XP Instrucciones De Operación página 8

Mini-Rooter XP™
HOW TO INSTALL 3/8" AND 1/2" CABLES IN
DRUM
DISCONNECT MACHINE FROM POWER
SOURCE BEFORE INSTALLING CABLES OR
To install cable in the drum, simply connect the male end
of the cable to the drum connecting cable, which is al-
ready attached to the drum. Then remove the drum V-
Belt and turn the drum clockwise, while pushing the cable
into the drum.
Note: The cable should lay in the drum in
a clockwise direction.
HOW TO USE J-DRUM
(Optional—Cat. #MR-250)
The J-Drum holds 50 feet of 1/4‖ or 5/16‖ cable to be
used when you need to clear smaller, 1-1/4‖ to 2‖ lines.
These cables have a basin plug head that can be spun
through most strainer crossbars. (See Cable Application
Chart—Table 1.)
DISCONNECT MACHINE FROM POWER
SOURCE BEFORE INSTALLING CABLES OR
1. To install cable, open chuck jaws fully so that cable
will pass through easily.
2. Slide the back end of the cable (opposite to the end
with basin head) through spout and into the drum.
The cable will be easier to install if you bend the last
inch of cable at a 45-degree angle.
3. When working through difficult stoppages or tight
bends, tighten the chuck to provide more torque and
to prevent the cable from tangling in the drum.
4. Clean and lubricate chuck regularly to prevent corro-
sion.
DRUMS!
DRUMS!
HOW TO USE DUAL-DRUM
(Optional—Cat #MR-280)
The Dual-Drum holds two different diameter cables at the
same time. Inner and outer drum compartments protect
the cable from tangling. You can easily switch from 1/4‖
to 5/16‖ or 3/8‖ cables without removing either one from
the drum.
DISCONNECT MACHINE FROM POWER
SOURCE BEFORE INSTALLING CABLES OR
1. Install 1/4‖ cable into the Dual-Drum by sliding the
back end of the cable (opposite to end with basin
head) through spout and into the inner drum.
cable will be easier to install if you bend the last inch
of cable at a 45-degree angle.
2. Install the 5/16‖ or 3/8‖ cable into the outer drum by
sliding the back end of the cable (opposite to the end
with the Female connector) through the spout.
Reach one hand into the drum through one of the two
ports in the face of the drum and pull the cable end to
the left side of the outer drum. Then push another
two feet of cable into the drum while pulling the cable
downward to form a loop. The cable should lay in the
drum in a clockwise direction.
Note: Use HE cables only in Dual-
Drum—not EM cables.
3. Select the appropriate cable for the line you are
working on. (See Cable Application Chart—Table 1)
If a 1/4‖ cable is required, reach into the Dual-Drum
and pull the cable out of the inner drum and through
the spout. If a larger cable is required, slide the 1/4‖
cable back though the spout, then reach into the
drum and pull the 5/16‖ or 3/8‖ cable from the outer
drum through the spout.
4. Each of the cables can be ―chucked‖ in place to pro-
vide more torque by pressing the knurled knob
against the spring and tightening it against the cable.
8
DRUMS!
The