Cleaning; Battery Pack Cleaning; Charger Cleaning Instructions - Black+Decker 190657 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2
3
4

CLEANING

WARNING: Always release pressure from the sprayer
prior to cleaning. Disassembly of a sprayer that is still
pressurized may result in the high-speed ejection of
components.
WARNING: RISK OF PERSONAL INJURY DUE TO
CHEMICAL EXPOSURE. Use the appropriate Personal
Protective Equipment (PPE) as recommended by the
chemical manufacturer and/or refer to the chemical
Safety Data Sheet (SDS) of the chemical being used.
This includes at least goggles, gloves, and protective
clothing.
WARNING: RISK OF DAMAGE TO INTERNAL
COMPONENTS. Failure to properly rinse out the
sprayer may allow chemical residue build-up that
can clog or damage the filters, pump, shut-off,
wand, and nozzle. Chemical residue build-up can
also contaminate subsequent applications. Leaving
chemical liquids in the sprayer when not in use can
lead to premature sprayer wear. Never store the
sprayer with chemicals in any part of the sprayer.
1. Ensure the sprayer is OFF and remove the battery
per the Removing the Battery section.
2. Remove the cap (1) and empty any extra
chemical from the tank into a suitable container
for later use or dispose according to the chemical
manufacturer's instructions.
3. Use clean water to thoroughly rinse and empty
the tank until all chemicals and residues are
removed.
4. Add approximately 1 quart (1 liter) of clean water
to the tank.
5. Insert the battery per the Installing the Battery
instructions and press the Power button (2) to
turn the sprayer ON.
1

Battery Pack Cleaning

Remove dirt and grease from the exterior of the
battery using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.

Charger Cleaning Instructions

6. Spray water through the pump, hose, shut-off,
wand, and nozzle for at least 30 seconds to rinse
them out. Failure to rinse out these components
may allow chemical residue build-up that can
clog or damage the components. After heavy
use, rinsing the nozzles may not be enough to
remove residue. The nozzles may need to be
cleaned with a small brush.
7. Empty out any remaining water from the tank
then continue to spray until water no longer
comes out of the nozzle. This indicates that most
of the water in the system has been removed.
8. Press the Power button (2) to turn the sprayer
OFF and remove the battery.
9. Squeeze the shut-off lever (B) to release any
remaining pressure in the hose.
10. Allow the sprayer to dry. This is best done by
removing the cap (1) and strainer basket (3) and
hanging the sprayer upside down to let it drain.
11. Once the sprayer is dried, turn the sprayer
upright and reinstall the strainer basket (3) and
cap (1) to prevent debris from entering the tank.
1
3
WARNING: Shock hazard. Disconnect the charger
from the AC outlet before cleaning. Dirt and grease
may be removed from the exterior of the charger using
a cloth or soft non-metallic brush. Do not use water or
any cleaning solutions.
ENGLISH
B
2
11

Publicidad

Tabla de contenido
loading

Productos relacionados para Black+Decker 190657

Tabla de contenido