NuWave OxyPure Manual Del Propietário página 12

INSTRUCTIONS
Solid Light
Rapid Blinking Light
Slow Blinking Light
No Light
Note: If the light on your unit is blinking slower, the unit is in
WiFi Standby Mode. To exit Standby Mode and initiate the
Pairing Mode, press and hold power for 2 seconds until the
WiFi light begins blinking rapidly.
Note: The OxyPure, as with most IoT devices (computing
devices), will only connect to a 2.4GHz* network.
To reset the OxyPure WIFI, press and hold down "Power"
•
for 3 seconds. Follow step 4 (from previous page). The
OxyPure can now be operated from any location.
*Most routers will broadcast in 2.4GHz. If you need help
activating 2.4GHz, contact your ISP (Internet Service Provider).
12 12
instructions
/WIFI CONNECTION
Wi-Fi LED Status
Pairing Mode & Standby Mode
The OxyPure is paired with the
Wi-Fi and ready to be used.
The OxyPure is in Pairing Mode.
The OxyPure will remain in Pairing
Mode for up to 3 minutes, or until
your device is paired.
The OxyPure is in Standby Mode.
The OxyPure's Wi-Fi is off.