Infiniton PAC-W12 Manual De Usuario página 27

sure to enable work to take place. This operation is absolutely vital if brazing operations on
the pipe-work are to take place.
Ensure that the outlet for the vacuum pump is not close to any potential ignition sources and
that ventilation is available.
CHARGING PROCEDURES
In addition to conventional charging procedures, the following requirements shall be follo-
wed.
 Ensure that contamination of different refrigerants does not occur when using charging
equipment. Hoses or lines shall be as short as possible to minimise the amount of refrigerant
contained in them.
 Cylinders shall be kept in an appropriate position according to the instructions.
 Ensure that the refrigerating system is earthed prior to charging the system with refrigerant.
 Label the system when charging is complete (if not already).
 Extreme care shall be taken not to overfill the refrigerating system.
 Prior to recharging the system, it shall be pressure-tested with the appropriate purging gas.
The system shall be leak-tested on completion of charging but prior to commissioning. A follow
up leak test shall be carried out prior to leaving the site.
DECOMMISSIONING
Before carrying out this procedure, it is essential that the technician is completely familiar
with the equipment and all its detail. It is recommended good practice that all refrigerants
are recovered safely. Prior to the task being carried out, an oil and refrigerant sample shall be
taken in case analysis is required prior to re-use of recovered refrigerant. It is essential that
electrical power is available before the task is commenced.
a. Become familiar with the equipment and its operation.
b. Isolate system electrically.
c. Before attempting the procedure, ensure that:
 mechanical handling equipment is available, if required, for handling refrigerant cylinders;
 all personal protective equipment is available and being used correctly;
 the recovery process is supervised at all times by a competent person;
 recovery equipment and cylinders conform to the appropriate standards.
d. Pump down refrigerant system, if possible.
e. If a vacuum is not possible, make a manifold so that refrigerant can be removed from various
parts of the system.
f. Make sure that cylinder is situated on the scales before recovery takes place.
g. Start the recovery machine and operate in accordance with instructions.
h. Do not overfill cylinders (no more than 80 % volume liquid charge).
i. Do not exceed the maximum working pressure of the cylinder, even temporarily.
j. When the cylinders have been filled correctly and the process completed, make sure that the
cylinders and the equipment are removed from site promptly and all isolation valves on the
equipment are closed off.
k. Recovered refrigerant shall not be charged into another refrigerating system unless it has
been cleaned and checked.
LABELLING
Equipment shall be labelled stating that it has been de-commissioned and emptied of refrige-
rant. The label shall be dated and signed. For appliances containing flammable refrigerants,
ensure that there are labels on the equipment stating the equipment contains flammable
refrigerant.