Yamato 52625 Manual De Instrucciones página 14

9
5. OPERATING INSTRUCTIONS
Bit installation
Insert the bit into the hole. Pay attention to align the bit correctly in the chuck.
Drill or impact selection
For drilling : Push the drill - impact selector where marked with
For impacting : Push the drill - impact selector where marked with
Rotation selection
It is possible to choose the rotation way selecting moving the lever (5) in a clockwise or
counter clockwise way, as showed in picture 6.
Forward/Reverse switch
Drill driver starts and stops by depressing and releasing the switch. To reverse the direction
of rotation, stop the driver by releasing the switch and push the reversing switch to the
right or the left. When the reversing switch is set to the right, the direction of rotation will be
clockwise, when viewed from the handle end of the drill.
When the reversing switch is set to the left, the direction of rotation will be
counterclockwise. Keep the reversing switch lever in the neutral position whenever you
are not using the tool.
Operating switch
To start operating with tool, press the switch (A), while to
stop release it.
It is possible to adjust the speed turning the speed device
(B). To increase the speed turn clockwise the device,
otherwise to reduce the speed turn counter clockwise.
When operating, it is possible to lock the switch pushing the
lock button (C).
Handle and ruler
We suggest to use always the handle, for safety purpose, and the ruler, to operate
correctly.
The ruler will permit to check how much you are performing. To adjust the ruler, unscrew
the knob, moving it forwards or backwards up to the required position.
Mechanical Speed Selector
(only mod.TPR1051/13-2)
Further the switch, which controls the speed electronically through the pressure applied on
the trigger switch, these drill drivers has a mechanical speed selector on the top of the
body.
It permits two more different level of speed where the position 1 is the lower and position 2
is the higher.
6. WARRANTY
This power tool is guaranteed for a period of 24 months, from possible defects of
manufacturing. Warranty shall cover regular operation of product and won't include
defects caused by wear, improper maintenance, tampering by unskilled people,
14