General Lubrication - Ingersoll Rand CL125K Manual Del Usuario

EN

General Lubrication

● Pneumatic Hoist Motors use oil to prevent excessive heat build up and to prevent wear. Oil levels must be properly maintained.
● Always collect lubricants in suitable container and dispose of in an environmentally safe manner.
Reduction Gear Assembly
Fluid level verification is recommended every 400 hours, or sooner depending on severity of use, of actual runtime.
The reduction gear assembly is oil lubricated, and is intended to be changed only at major overhaul intervals. It is recommended that the gear
cover not be removed to prevent contamination.
The recommended grade of oil for the gearbox is Dextron III ATF. Oil Capacity for reduction gear assembly is 1.35 oz. (40 ml).
Motor
The recommended grade of oil for the air motor is IR #10 (10W non-detergent) tool oil.
Load Chain
Failure to maintain a clean and well-lubricated load chain will result in rapid load chain wear that can lead to chain failure which may
result in death, severe injury, or substantial property damage.
1. Lubricate each link of load chain weekly, or more frequently, depending on severity of service.
2. In corrosive environments, lubricate more frequently than normal.
3. Lubricate each link of the load chain and apply new lubricant over existing layer.
4. Use Ingersoll Rand LUBRI-LINK-GREEN® or an ISO VG220 to 320 (SAE 50W to 90 EP) oil.
Warranty
Ingersoll Rand Limited Warranty
Ingersoll Rand Company ("IR") warrants to the original user its material handling products ("Products") to be free of defects in material and
workmanship for a period of one year from the date of purchase. IR will, at its option either (1) repair, without cost, any Product found to be
defective, including parts and labor charges, or (2) replace such Products or refund the purchase price, less a reasonable allowance for
depreciation, in exchange for the Product. Repairs or replacements are warranted for the remainder of the original warranty.
If any Product proves defective within its original one-year warranty period, it should be returned to any Authorized Product Service Distributor,
transportation prepaid with proof of purchase or warranty card. This warranty does not apply to Products which IR has determined to have
been misused or abused, improperly maintained by the user, or where the malfunction or defect can be attributed to the use of nongenuine
IR repair parts.
IR MAKES NO OTHER WARRANTY, CONDITION OR REPRESENTATION OF ANY KIND WHATSOEVER, EXPRESSED OR IMPLIED, STATUTORY
OR OTHERWISE, AND ALL IMPLIED WARRANTIES AND CONDITIONS RELATING TO MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, ARE HEREBY DISCLAIMED.
IR's maximum liability is limited to the purchase price of the Product and in no event shall IR be liable for any consequential, indirect incidental
or special damages of any nature arising from the sale or use of the Product, whether in contract, tort or otherwise.
Note: Some states do not allow limitations on incidental or consequential damages, so that the above limitations may not apply to you. This
warranty gives you specific legal rights and you may also have other rights which may vary from state to state.
Fulcrum series electric winch, product code 405-002: 2 year warranty.
Winch and Hoist Solutions Extended Warranty
This option provides a price for extending the Ingersoll Rand Winch and Hoist Solutions Warranty from the standard one (1) year to two (2)
years from the date of purchase. All other provisions of the standard warranty to remain in effect.
For additional information or quotations for warranties falling outside of these parameters, please contact your Client Services Representative
with your requirements.
EN-7
WARNING
NOTICE
WARNING
45550183_ed4