Tool Status Lights; Specifications; Standard Equipment - RIDGID RP 342-XL Press Tool Manual

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

RP 342-XL Press Tool
Figure 5 – Tool Status Lights

Specifications

Attachments ...............RIDGID Standard Series
Stroke Length............."Standard" Configuration
1.57" (40 mm)
Duty Cycle..................3 Press
Ram Force ................32 kN (7,200 lbs.)
Motor
Voltage ...................18V DC
Amperage ...............27.2 Amp
Power .....................490 Watts
Power Supply .............RIDGID RB-18XX Series18 V Li-Ion Batter y Pack
Operating Temperature
Range ...........................15° F to 122° F (-10° C to 50° C)
Weight (no battery/
attachment)...................10.8 lbs. (4.9 Kg)
Height.........................10.5" (267 mm)
Width ..........................3.35" (85 mm)
Length ........................20.9" (531 mm)

Standard Equipment

Refer to the RIDGID catalog for details on equipment
supplied with specific tool catalog numbers.
Selection of appropriate materials and joining
NOTI E
methods is the responsibility of the system designer and/or
6
Solid Light
Blinking Light
Icon
Green
Red
Yellow
/min.
Meaning
Tool ON, ready to use.
Green
Low voltage. Tool will not operate. Battery - Recharge,
AC Adapter - Change power source, remove extension cords.
Tool out of Specification temperature range. Bring tool
and battery to correct operating temperature range.
Indicates service interval approaching. Light turns on after
Yellow
18,000 cycles to show service interval is approaching. Tool is
usable, but tool willlock after service interval (20,000 cycles).
Tool locked. Service interval complete (20,000 cycles) and
requires service.
Tool has malfunctioned. Remove and reinsert battery. If still
ON, have tool serviced.
RIDGID Extended Series/RIDGID Approved
"Extended" Configuration
3.15" (80 mm)
3 Press
/min
installer. Before any installation is attempted, careful eval-
uation of the specific service environment, including chem-
ical environment and service temperature, should be
completed. Consult Press Fitting System manufacturer
for selection information.
999-999-207.10_REV. A

Publicidad

Tabla de contenido
loading

Tabla de contenido