Threading The Cable Through The Top Frame Of The Weight Tower - Precor Discovery Selectorized Serie Manual Del Propietário

Threading the Cable Through the Top Frame of the
Weight Tower
The cable passes through an opening in the top of the weight tower frame,
over the pulleys and then back down through the frame to the weight stack.
Use the following procedure to remove both cable retainers and the pulley that
covers the opening where the cable passes upward through the frame.
Figure 12: Position of cable over pulleys
To route the cable through the weight tower:
1. Locate the pulley positioned over the opening where the cable will thread
up through the weight tower. Using a ³ ₄-inch socket wrench and a ³ ₄-inch
open-end wrench, remove the bolt, and then remove the pulley and cable
retainer.
Figure 13: Removal of pulley and cable retainer
Leg Press Assembly Guide: Routing the Cable Assembly
2. Thread the cable up through the weight tower frame. Replace the pulley
and cable retainer making sure that the cable is positioned in the pulley
trough and under the cable retaining bracket. Tighten the bolt to 500 in-lb
(56 N-m) of torque.
Note: When properly installed, the cable retainer keeps the cable securely
seated in the pulley. However, the retainer must not contact the cable
while the cable is under load (for example, during a workout).
Figure 14: Proper position of cable under cable retainer
9