Cequent Towing Products 75506 Instrucciones De Instalación

Frame
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75506F
Wrenches: 3/4", 7/8", 21mm
Drill Bits: None
Frame Rail
1
Qty. (2) Hex Bolt, 1/2"-13 x 1-1/2"
2
Qty. (12) Conical Washer, 1/2"
3
Qty. (6) Nut, 1/2"
1. Raise hitch into position as shown in Figure 1.
2. If the small brackets on the hitch do not go between the ends of the saddle bracket on the vehicle's bumper, the bumper may be
loosened and recentered. After adjustment, tighten the M14 OE flange nuts to 148 lb-ft (201 N-m). See Figure 2.
3. Install all fasteners as shown. Make sure that spacers are placed between the back of the frame and the hitch.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Installation Instructions
Ford F-150
Lincoln Mark LT
Bumper
Fascia
ALL FASTENERS TYPICAL
FIGURE 1
Tighten all 1/2" GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: PU3
BOTH SIDES
Bumper
Saddle Bracket
4
Qty. (4) Hex Bolt, 1/2"-13 x 2"
5
Qty. (2) Spacer, 1/4" x 1" x 2"
Sheet 1 of 3 75506N
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT
10,000 lb (4,540 kg)
6,000 lb (2,724 kg)
FIGURE 2
04-13-06
75506
44552
87418
Max Tongue
WT
1,000 lb (454 kg)
600 lb (272 kg)
OE Nuts
Rev. A