Cequent Towing Products 75155 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: F75155
Wrenches: 1/2",3/4",10mm,12mm,13mm,17mm
Drill Bits: NONE
Other: Tin Snips, Tape
Note! Requires removal of factory hitch if equipped.
This requires the rear fascia to be removed and reinstalled.
Vehicle
Rearward
Bracket tab bolting
locations.
FIGURE 2.
For TOYOTA Only
Tow hook, remove
and return to
customer.
j
Qty. (6) Hex bolt M12 x 1.25 x 40mm CL10.9
k
Conical washer 1/2"
Qty. (6)
l
Qty. (2) Hex bolt M8 x 1.25 x 30mm CL10.9
m
Conical washer 3/8"
Qty. (2)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body
panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety
precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.
2006, 2007, 2008 Cequent Towing Products – Printed in Mexico
z
Installation Instructions
Toyota 4Runner
Fascia tabs
Impact bar
ml
Tighten all 1/2" GR5 Handle nut bolts with torque wrench to 50 Lb.-Ft (68N*M).
Tighten all M8 fasteners with torque wrench to 20 Lb.-Ft (27N*M).
Tighten all M12 fasteners with torque wrench to 68 Lb.-Ft (92N*M).
Lexus GX470
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV1, SUV2
n
jk
n
Qty. (2)
o
Qty. (2)
p
Qty. (2)
q
Qty. (4)
Sheet 1 of 6
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
7300 (3314 Kg)
6000 (2724 Kg)
Access holes
for handle-nut
and blocks
FIGURE 1.
For LEXUS - See next page.
Handle nut assembly 1/2"-13
Hex Bolt ¼" X 1" (Not Shown)
Flange Nut ¼" (Not Shown)
Cable tie
N75155 08-16-11
75155
44548
70779
Max Tongue
WT (LB)
730 (331 Kg)
600 (272 Kg)
Existing
weld-nuts
Impact
bar
jk
Rev. F