Assembly - Attaching The Fan Blades And Brackets - Hapton Bay 91646 Guía De Uso Y Cuidado

Assembly - Attaching the Fan Blades and Brackets

5
Attaching the blades to the blade
brackets
NOTE: Your fan blades are reversible. Select the blade
side finish which best accentuates your decor.
□
Attach a blade (E) to a blade bracket (D) by inserting blade
attachment screws (AA) into the holes in the blade (E) and
through the blade bracket (D). The rubber washers are preat-
tached to the blade bracket (D).
□
Tighten each screw securely.
□
Repeat these instructions for each blade (E) and blade bracket (D).
Assembly - Attaching the Light Kit Fitter Assembly
7
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit.
□
Remove the three screws on the black bracket below the fan-
motor assembly (C).
□
Connect the wires from the light kit fitter assembly (F) to the
wires from the black bracket below the fan-motor assembly
(C) by connecting the molded adaptor plugs together.
□
Carefully tuck all wires and splices in the switch cup.
□
Position the switch cup of the light kit fitter assembly (F) on
the black bracket below the fan-motor assembly (C) and align
the three holes in the black bracket.
□
Re-install the three screws removed at the beginning of this
step to secure the light kit fitter assembly (F).
F
AA
E
C
6
Fastening the blade assemblies to
the motor
□
Fasten the blade assembly to the fan-motor assembly (C) by
inserting the alignment post into the slot on the bottom of the
motor and tightening the blade bracket (D) screws. The blade
bracket screws are pre-installed into the blade bracket (D).
□
Repeat this step for the remaining blade assemblies.
D
8
Installing the glass shades and
bulbs
WARNING: Allow the glass shades to cool completely before
removing.
CAUTION: Make sure the power is off before attaching or
removing the glass shades.
□
Insert the glass shade (G) into the glass holder by carefully
squeezing the steel tensioners on the light fixture socket
together.
□
Gently slide the glass shade (G) over the steel tensioners.
Make sure the glass shade (G) is fully inserted into the socket
for a secure fit. Repeat these instructions for the remaining
glass shades.
□
With the power off, insert the light bulbs (H) (maximum 9.5W)
(included) into the light sockets.
□
Attach the pull chains extensions (DD) to the light pull chain
and the fan pull chain.
9
Please contact 1-855-HD-HAMPTON for further assistance.
E
F
G
H
C
D
DD
HAMPTONBAY.COM