Cequent Towing Products 36427 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 36427F
Wrenches: ¾, 19mm
Drill Bits: None
1 1 1 1 Qty. (2) ½-13 x 1.75
2 2 2 2 Qty. (4) ½ Conical Toothed Washer
1. Raise hitch into position and align the slots of the receiver with the weldnuts in the frame rail.
2. Install the M12 X 1.25 X 40mm bolts and conical toothed washer through the hitch and into the weldnuts.
3. Insert the handle nuts through the large hole in the vehicle frame rail as shown above.
4. Install the ½-13 X 1.75 bolts and conical toothed washers.
Tighten all M12 X 1.25 CL 10.9 fasteners with torque wrench to 130 Lb.-Ft. (176 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2006, 2015 Cequent Towing Products – Printed in México
Installation Instructions
(Sold separately)
Fascia
Drawbar Kit:
36061
Drawbar must be used in the
Rise position only.
Frame Rail
Tighten all 1/2-13 GR 5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Acura RDX
Do Not Exceed Lower of Towing Vehicle
3500 LB, (1589 Kg) Max Gross Trailer Weight
Wiring Access Location: SUV1, SUV2
3 3 3 3 Qty. (2)
4 4 4 4 Qty. (2)
Sheet 1 of 3
Manufacturer's Rating or
300 LB, (136 Kg) Max Tongue Weight
Existing Weldnut – Both Sides
M12 X 1.25 X 40mm CL 10.9
½ Handle Nut
36427N 10-13-15
Form: F205 Rev A 5-6-05
Part Numbers:
36427
06465
90162
36319
Rev. C