Mounting The Internal Autoloader A - Seagate Scorpion 240 DDS-4 Manual De Instalación

Scorpion 240 Autoloader Installation Manual
Mounting the internal autoloader
The Scorpion 240 must be mounted horizontally in a 5.25-
inch, full-height drive bay. Mount the drive using four M3.0
metric screws on the sides or bottom of the drive, as shown in
Figure 3. Do not use screws longer than 4 mm or you may
damage the drive.
Note. When mounting the drive, make sure that nothing
Figure 3. Locations of mounting holes
7.0
± 0.3
blocks the exhaust fan or the ventilation slots on the
bottom and rear of the autoloader.
45.5
± 0.25
45.5
± 0.25
79.5
± 0.25
MOUNT HOLE
M3 (4 PLACES)
203.2
± 0.25
224.0 max
MOUNTING HOLE
M3 (4 PLACES)
79.5
± 0.25
203.2
± 0.5
224.0 max
A-15