Connecting A Power Cable A - Seagate Scorpion 240 DDS-4 Manual De Instalación

Scorpion 240 Autoloader Installation Manual
chain and attach an LVD/single-ended multi-mode terminator
to the last connector in the chain.
Figure 5. Two SCSI termination examples for the internal
Scorpion 240.
SCSI Terminator
SCSI device
SCSI Controller
(termination enabled)
Connecting a power cable
Attach a 5/12-volt, four-pin power cable to the power
connector on the back of the drive. Figure 4 on the previous
page shows the location of the power connector.
The recommended 4-pin power connector for the internal
drive is an AMP 1-48024-0 housing with AMP 60617-1 pins or
equivalent.
Internal
Tape drive
(no
termination )
( termination
disabled )
SCSI device
( termination
enabled )
Internal
Tape drive
(no
termination )
SCSI device
( termination
disabled )
SCSI Controller
(termination enabled)
A-17