Installing/Removing Battery Pack; Starting/Stopping The Blower; Operating The Blower - Hart HLBL02VNM 40V Manual Del Operador

OPERATION
NOTICE:
Before each use, inspect the entire product for
damaged, missing, or loose parts such as screws, nuts,
bolts, caps, etc. Tighten securely all fasteners and caps
and do not operate this product until all missing or
damaged parts are replaced. Please contact customer
service or an authorized service center for assistance.
APPLICATIONS
You may use this product for the purposes listed below:
 Clearing leaves and other debris from your lawn
 Keeping decks and driveways free from grass clippings,
leaves, pine needles, and other debris

INSTALLING/REMOVING BATTERY PACK

See Figure 3.
WARNING:
Always remove battery pack from your tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
To install:
 Place the battery pack in the blower. Align the raised rib
on the battery pack with groove in the blower's battery
port.
WARNING:
Make sure the latch on the bottom of the battery pack
snaps in place and the battery pack is fully seated
and secure in the blower battery port before beginning
operation. Failure to securely seat the battery pack
could cause the battery pack to fall out, resulting in
serious personal injury.
NOTICE:
When placing battery pack in the tool, be sure raised
rib on battery pack aligns with the bottom of the tool
and latches into place properly. Improper installation
of the battery pack can cause damage to internal
c omponents.
To remove:
 Locate the latch and depress to release the battery pack
from the blower.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be in the OFF position
when not in use or carrying at your side. Remove
battery pack when transporting or carrying blower to
avoid accidental starting, which could result in serious
injury.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.

STARTING/STOPPING THE BLOWER

See Figure 4.
 To start the blower, depress the switch trigger.
 To stop the blower, release the switch trigger.

OPERATING THE BLOWER

See Figure 5.
 To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
 To reduce sound levels, limit the number of pieces of
equipment used at any one time.
 Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
 Conserve water by using power blowers instead of hoses for
many lawn and garden applications, including areas such
as gutters, screens, patios, grills, porches, and gardens.
 Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
 After using blowers or other equipment, CLEAN UP!
Dispose of debris properly.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be in the OFF position
when not in use or carrying at your side.
7 – English