Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

257*182mm
USE AND CARE GUIDE
8-PACK PUCK LIGHTS WITH REMOTE CONTROL
Safety Information
Use caution and common sense when operating your puck light.
Failure to adhere to the safety warnings and guidelines in this manual could result in body injury or property
damage. Save this manual for future reference.
WARNING: Read and follow all warnings
and instructions in this manual to avoid
personal injury or property damange.
1. This product is not a toy and contains small parts. Close supervision is necessary when this unit is used near children or
operated by children.
2. For cleaning, use a soft dry cloth. Do not place or store appliance where it can fall or be pulled into a tub or sink.
Warranty
□This product is guaranteed to be free of defects in materials and workmanship for 1 year from the date of purchase. If this
product is defective, call 866-308-3976 for repair of replacement parts or return the product to the store from which it was
purchased.
□Guarantee does not include normal wear and tear, LED or batteries.
Pre-Operation
1. Package Contents
C
A
B
D
2. Battery Installation and Replacement
Item #: 1002484076
Puck Lights-Each light requires 3 AAA batteries (C).
Model #: 99657
□ Remove the battery cover by rotating to "
position as indicated.
□ Place 3 AAA batteries (C) into the battery
compartment aligning polarity (+) (-) as indicated.
□ Replace the battery cover, ensure the " " on the
upper and bottom cover are aligned, and turn to the
"
Remote Control-One piece CR2025 button battery pre-installed.
Remove the insulation sheet upon rst use. Follow these steps to
activate or replace the battery:
□ Slide the battery drawer out.
□ Remove the battery.
□ Place a new battery in position aligning polarity(+) (-) as indicated.
□ Slide the battery drawer in.
Operation
1. Operating the Puck Lights
A. Operating by Touch Control
Once the 3 AAA batteries are installed, turn on each puck by lightly pressing the Dome
Cover. Repeat pressing the Dome Cover to change the color (white, red, green, or
blue) or turn the unit OFF.
B. Operating by Remote Control
□ Press "
□ "
increase and decrease brightness separately.
□ "
lights ON rst and select duration among 10, 30, 60, or 120 minutes.
WARNING: To prevent damange to eyesight,
never look into light when the light is on. Do not
Lights will ash once to con rm command. Timer clears when lights
shine light into the face of someone else.
turn OFF.
□ Color selector- Change color of LEDs to be white, red, green or blue.
□ All lights will return to the prior color when turned ON.
2. Mounting Instructions
Remove the protective paper on one side of the mounting pad (D) and apply to the
battery cover (use caution as the adhesive is very strong). Decide a location to
position the light. Remove the second protective paper and apply pressure to set
the adhesive. Once applied the light is permanently mounted.
Care and Maintenance
□ When replacing batteries always replace the whole set.
□ Use same brand and same type of batteries in the same light.
□ Do not use rechargeable or reusable batteries
□ Follow battery manufacturer's instructions as to proper handling, storage and disposal of batteries.
Troubleshooting
Part
Description
Quantity
A
Puck Light
8
□ If the light does not work, make sure the battery is installed correctly or brand new.
B
Remote Control
1
□ If the remote control does not work, make sure the plastic sheet is removed and battery is installed correctly or brand new.
C
AAA Heavy Duty Battery
24
□ If the remote control is not working properly, make sure there is no obstacle between you and the puck light(s), and that
D
Mounting
8
the remote is not positioned too far away from the lights.
FRONT
"
"position.
10
30
MIN
MIN
60
120
MIN
MIN
" to turn all lights ON, press "
" to turn all lights OFF.
" is to control brightness of all lights. Press and hold (+) or (-) to
" is to control the amount of time the lights stay ON. Turn the
10
MIN
60
MIN
DOME COVER
30
MIN
120
MIN

Publicidad

loading

Resumen de contenidos para Defiant 99657

  • Página 1 257*182mm 2. Battery Installation and Replacement Item #: 1002484076 Puck Lights-Each light requires 3 AAA batteries (C). Model #: 99657 □ Remove the battery cover by rotating to “ ” position as indicated. □ Place 3 AAA batteries (C) into the battery compartment aligning polarity (+) (-) as indicated.
  • Página 2 2. Instalación y reemplazo de las baterías Núm. de artículo #: 1002484076 Luces de disco-Cada lámpara requiere 3 baterías de tamaño AAA (C). Núm. de modelo #: 99657 □ Gire la cubierta de las baterías a la posición “ ” que se indica para retirarla.

Este manual también es adecuado para:

1002484076