Brandson Equipment 304257 Manual Del Usuario página 17

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Rain Delay function
This feature is not supported by this device. If you accidentally set a Rain Delay (is
shown at the bottom of the screen),
press the "Increase value" and "Decrease value" arrow keys simultaneously to
disable the Rain Delay function.
7. Manual operation
You can override the automatic watering cycle with the manual operation.
1.
Press the manual button (Man.) to access manual operation.
2.
Adjust the watering duration (Run Time) using the dial. The run time can be
configured to a maximum of 240 minutes.
3.
Then press the OK button to confirm.
4.
To turn off the manual operation and switch to automatic mode, press the
manual (Man.) button.
8. Additional safety instructions
• The timer is water resistant, NOT water proof. The timer has to be installed
above ground and vertically to the tap. Do not immerse the device in water!
• DO NOT pull the hose when it is connected to the watering control system to
avoid damage to the timer.
• This timer is intended for outdoor use, to control watering systems.
• The device should not be used for industrial purposes
• The water pressure is between 0.2 bar and 8 bar (0 psi to 116 psi).
Use only with clean water and fresh water, the water temperature has to be
above 1°C and below 60°C.
• Protect the timer during winter season or from frost. Disassemble the device
from the tap and drain all the water from it. Remove the batteries and keep the
device and the batteries safely at home.
• Always keep the cover closed to prevent water from entering.
• Do not use the device if it has fallen down or has been subject to impact.
• Ensure that you clean the filter regularly if it is dirty.
English
17

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

20191212nb128

Tabla de contenido