Typical Installation - Porter Cable PXCM024-0271 Manual De Instrucciones

Herramienta cortadora neumática de 76 mm

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Key Description

Air hose

In-line Filter

Tee Fitting

To begin using the tool:

As a standard practice, drain water from the air

compressor tank and air lines prior to use each day

(reference your compressor operators manual for

detailed instructions).

Install a 1/4" NPT male plug into the air inlet port on

the tool (see Figure B). Note: Use Teflon® Tape

on all threaded connections.

Turn on the air compressor and allow it to build up

pressure.

Always disconnect the tool from the

air source before changing cut-off disks. Do not

operate the tool if the cut-off disk is not tightened to the

cut-off tool.

Assemble the cut-off disk to the cut-off tool (see

Figure C): NOTE: Use only 3" maximum diameter

cut-off disks rated at no less than 20,000 RPM. For

replacement aluminum oxide cut-off disks, call the number listed on the back page of this manual.

Place the allen wrench (included with tool) in the allen head screw

at the end of the tool and the spanner wrench (included with tool)

on the body of the tool to hold it from turning. Turn the allen

wrench counterclockwise to loosen.

Remove the allen head screw and washer.

Place a cut-off disk, rated for the tool, onto the arbor and replace

the washer and allen head screw.

Tighten the allen head screw clockwise with the allen wrench.

Never use a damaged disk! Inspect the cut-off disk for

cracks or chips before using.

Never operate this tool without the guard attached or

if the guard is damaged. Serious injury may occur if used without the

guard in place. Position the guard between yourself and the part being

cut.

Adjust the air compressor's regulator or the supply line regulator to 90 PSI.

Connect the tool to the air hose quick coupler. NOTE: It is recommended that a whip hose with a swivel

(not included) be used to prevent twisting, kinking, and excessive wear to the air hose (see Figure A

for recommended connections).

Squeeze trigger gently. Start the tool off the work. Do not put extreme pressure on the tool. This slows

down the speed of the cut-off disk, reducing cutting efficiency and puts additional burden on the air tool

motor.

When finishing cutting, lift the tool off the work before releasing the trigger.

This tool will produce sparks when cutting metal. Always wear ANSI Z87.1 approved

safety goggles when using this tool.