Utilitech 7105-04-L Manual Del Usuario página 9

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
4. Mount the fan housing (A) to joist using the long wood
screws (AA) on both sides.
Hardware Used
AA
Long wood screw
5. Remove wiring box cover (5.1). Pull the house wires
through the wire box cover hole. Using a quick connector,
secure 120 V AC house wiring from the wall switch to the
fan as shown in the wiring diagram on page 5. 14 AWG
is the smallest conductor that should be used for branch-
circuit wiring.
Carefully push the connected wires back into the wiring
box housing. Reattach the wiring box cover (5.1).
CAUTION: If the electrical wires do not match the
colors listed, you must determine what each house wire
represents before connecting. You may need to consult
an electrical contractor to determine safely.
6. Install a circular 4 in. duct (6.1) (not included) and secure
it with duct tape or clamps (neither included).
Finish ceiling work. Ceiling hole should be aligned with edge
of fan housing (A).
7. Plug light/rim assembly (B) into the fan housing (A).
4
x 4
Joist
Ceiling board
5
House
wires
6
A
7
A
B
9
AA
A
Quick
connector
Product
wires
5.1
6.1