How To Install Your Canopy Housing - Fanimation ODYN MAD8152 Serie Manual Del Usuario

How to Wire Your Ceiling Fan (Continued)
Yellow
Red
Gray
Black
Blue
Black / White
4. After connections have been made, put the white and green leads to one side and the black/white leads
towards the other side, upward and carefully push leads into the outlet box. The wires should be spread apart
with the grounded conductor and the equipment-grounding conductor on one side of the outlet box and the
ungrounded conductor on the other side. (Figure 5)
NOTE: This step is applicable after the neccessary wiring is completed.
1. Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care not
to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that was
previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figrue 2)
BLK-ANT
Green / Yellow
- Ground wire (2)
Listed
Outlet Box
From Receiver
Green-
Ground wire
From Ceiling
Green-Ground Wire
White
From Hanger Bracket
Green-Ground Wire
From Hanger Ball

How to Install Your Canopy Housing

WARNING
Green Wire
from Supply
(Ground)
Green Wire
from Hanger
Bracket (Ground)
Green Wire
from Receiver (2)
(Ground)
Green Wire
from Hanger
Ball (Ground)
Figure 5
11
White Wire
Listed
from Supply
Outlet Box
Household
Supply
White Wire
from Receiver
Black Wire
from Supply
Receiver
Black/White Wire
from Receiver
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2