Safety Tips - savic Dog Barrier Door Manual De Instrucciones

secure by fully tightening the locking rings (C). Next, adjust the top screw
adjusters (B), once again ensuring that your gate is central. Tighten the
locking rings (C) until the handle is aligned.
Once the bars of the inner and outer frame are parallel you can mark the
position of your wall cups (D2) with a pencil. Remove the gate and secure
your wall cups (D2) to your wall, doorway or stairway using the sticky pads
(D3) or screws (D1 + D4) provided (Do not use sticky pads on wall paper or
where there may be other loose materials).
If using the screws, first drill a 1/4" (6 mm) hole into your wall and insert
the wall plug, then secure the wall cup with the screw. If you are drilling
into plaster board you will need to purchase expandable wall plugs
(available from DIY stores).
You can now refit the Dog Barrier door as instructed above.
Check that your gate is securely fitted. This check should be repeated daily
to ensure that your gate remains securely fixed and that all attachments
and locking devices are operating correctly.
Using your Dog Barrier door
To open your gate: Press the button, lift the lever and raise the door slightly.
To close your gate: Align the handle with the frame and lower the lever
until it clicks into place.

Safety tips

• Pets still need supervision and should not be left alone until they
become familiar with the gate.
• A daily check on the gate is recommended to ensure that your gate
remains securely fixed.
• Ensure that the gate is properly closed at all times.
• The gate is designed for indoor use only.
• A swinging gate can trap small hands.
• Dog Barrier is recommended for dogs, not for children.
• Do not allow older children to climb on or over the gate as this can result
in an accident.
• Do not remove the safety instructions, you may not always be the user.
• Retain these instructions as you may wish to reposition the gate.
• Warning! Incorrect fitting or positioning of this safety barrier can be
dangerous.
• Warning! Do not use the safety barrier if any components are damaged or
missing.
• Warning! This barrier must not to be fitted across windows.
It should only take 5 minutes to fit your gate. We recommend that you
carry out the installation away from young children as some of the smaller
components may present a choking hazard when loose.
3
(3)
F
F
3
3