Above Floor Cleaning - Bissell POWERTRAK 2598 Serie Guia Del Usuario

Install Febreze Filter*
WARNING
position and that the filter is in place. DO NOT operate your vacuum without the filter.
1
Press top of Dirt Tank
to release it from the
vacuum base.
NOTE: Your vacuum comes with a standard foam filter (yellow) located in the top of of the
Dirt Tank. A separate Febreze foam filter (black) may also be packed in the box. Both are
washable. Over time, the Febreze filter will begin to lose scent after use and washing.
Power ON & Settings
1
Turn the dial on the foot of the vacuum to desired
setting. If dial is difficult to turn, tilt vacuum back.

Above Floor Cleaning

1
Pull hose up and out of
vacuum base to attach
your desired tool.
NOTE: Before above floor cleaning, remove the TurboBrush® Tool Clip and
TurboBrush Tool from the handle.
Certain trademarks used under license from The Procter & Gamble Company or its affiliates.
6
www.BISSELL.com
Before using your vacuum, make sure that the Dirt Tank is in locked
2
To access the filter, twist the
top of tank counter-clockwise
to unlock and reveal filter.
Bare Floor Setting -
For bare floors or low
pile carpet.
High Carpet Setting -
For high pile and most
shag carpet.
2
For extended reach, lift the
Quick Release Lever on the
back of the vacuum to slide
the Quick Release Handle
out of the base.
*Included separately
3
Replace standard yellow
foam filter with Febreze
black foam filter to freshen
as you vacuum.
2
Press down once on the red ON/
OFF pedal located on the lower
back of the vacuum to turn ON.
Press down again to turn OFF.
Remove the hose from
the hose wand base and
connect to the open inlet at
the handle. Connect desired
tool to the end of the wand.