Checking Connections; Trimmer Functions - Beninca CELL.P Manual Del Usuario

CELL.P control unit with microcontroller
Terminals
1, 2, 3
4, 5, 6
7
8-9
10
11
12
13
14
15
16,17
18,19
20,21
1) Cut off power supply.
2) Manually release the door, move it at around half stroke and lock it again.
3) Reset power supply.
4) Send an opening control signal through the OPEN input.
5) The door leaves should open. If not, with stopped motor, it is sufficient to invert the move wires of
the motor (MOT/MOT) of the motor and the limit switches (SWO/SWC), if used.
6) Adjust Times and operating Logics.
TW It allows the maximum duration of opening and closing.
It must be preset approx. 4s more with respect to the actual stroke time of the system.
The adjustment ranges from 3s to 180s maximum.
TCA It allows to adjust the automatic closure time.
The adjustment ranges from 3s to 180s maximum.
INPUT/OUTPUT FUNCTIONS
Function Description
Input, 230VAC 50/60Hz
Power supply
(1-Phase/2-Neutral/GND-Ground connection)
Connection to motor:
Motor
(MOT-move/COM-Common/MOT-move)
LAMP Output, connection to Flashing light: 230 Vac 40W max.
Connection to capacitor
Capacitor
SWO Input, OPENING limit switch (Normally Closed contact)
SWC Input, CLOSING limit switch (Normally Closed contact)
Safety edge or photocell Input
DAS/ PHOT
See DIP-SWITCH 3.
CLOSE Input, CLOSE key (N.C. contact)
COM Common, all control inputs.
Input, OPEN key (N.O. contact).
OPEN It is possible to connect a timer for opening in time slots. Con-
tact CLOSED:gate open, Contact open:normal operation.
24Vac Output, 24Vac/400mA max accessory power supply.
Contact free from voltage, not insulated for the connection of
open gate indicator lamp.
SCA Open contact with closed door leaf. Flashing light during
the door leaf movement. With open door leaf, the contact is
closed.
Connection of the antenna to the incorporated radio-receiver
Antenna
module (SHIELD-screen/ANT-signal).

CHECKING CONNECTIONS:

TRIMMER FUNCTIONS

EN
9