Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
11. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Locate ON/OFF slider switch
on wall control and set to the ON position. Test
light and dimmer function and then test fan
speeds. Next, locate remote control transmitter.
Test fan speeds with the different fan speed
buttons on remote control. Test the light ON/OFF
function with the
button on the remote control.
Test dimmer function by holding the
the remote control operates all of the functions of
the fan and light, battery has been installed
correctly. If fan and/or light do (does) not function,
please refer to "Troubleshooting" section to solve
any issues.
Fan must be on LOW before setting the fan to
reverse direction. Use
front of the remote control or on the front of the
wall control) to recirculate air depending on the
season. A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
IMPORTANT: Remote and wall controls must be
synchronized with fan in order to properly
function.
-
I
VI
button. If
button (located on the
page 10
remote control
transmitter
IV
III
II
V
I
VI
wall control
III IV
II
V
VI
I
OFF
ON
Publicidad
Capítulos
Tabla de contenido
