Fan Assembly. Pgs - Craftmade OV70AG Guia Del Usuario

5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging ball
and remove stop pin and then slide hanging ball off of
the downrod. [Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing yoke.
[Refer to diagram 2.]
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
[Refer to diagram 2.]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack from
the upper end of the downrod. [Refer to diagram 2.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip that were previously removed. Tighten yoke set
screws and nuts securely. [Refer to diagram 2.]
Locate canopy cover in hardware pack. Slide yoke cover,
canopy cover and canopy over downrod. [Refer to
diagram 3.] (Note: Canopy cover must be turned with
shiny side toward the motor housing.)
Thread safety cable and wires through hanging ball;
then slide hanging ball over downrod--the top of the
downrod should be noted as having a set screw hole;
use this hole when setting the set screw. Insert stop pin
into top of downrod and raise hanging ball. Be sure stop
pin aligns with slots on the inside of the hanging ball.
Tighten set screw securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw completely
could result in the fan becoming loose and possibly
falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
diagram 1
electrical
wiring
downrod
clip
diagram 2
downrod
canopy
yoke cover
diagram 3
stop pin
diagram 4
page 4
stop pin
hanging ball
safety
cable
yoke set
screw
and nut
pin
canopy
cover
motor
housing
set screw hole
hanging
ball