Tabla de contenido
Publicidad
Nigra Top LED
PRECAUTIONS:
• Keep the product out of the reach of children.
• Do not immerse this product in water or handle it with wet hands.
• Do not hit the product.
• Do not install the product where there are heat sources or moisture
concentrations.
• Do not handle the product while it is in operation and allow it to cool before
touching it with your hands.
• The product must not be covered with thermal insulation material under
any circumstances.
• Maintain a minimum distance of 1m from the surface or object to be
illuminated.
• If the product is damaged, replace it immediately with a new one.
• Disconnect power before installing the product.
• This product contains components sensitive to static electricity and a
discharge to it could destroy or damage its components.
• Before carrying out any work or maintenance, make sure that the device is
completely disconnected from the power supply.
• The replacement or maintenance of any component must be carried
out with the same elements recommended and supplied by the
manufacturer himself. If this is not the case, any incident on an installation
that has not been carried out in accordance with this instruction sheet is
the responsibility of the installer.
• If the flexible cable or cord of this luminaire is damaged, it must only be
replaced by the manufacturer or its technical service or a person of
equivalent qualification in order to avoid any risk.
• The light source of this luminaire must be replaced only by the manufacturer,
its technical service or equivalent qualified person.
• Between the low voltage power supply and the control conductors the
insulation is reinforced insulation.
P
LED
18W
24W
36W
48W
72W
32W
48W
64W
96W
1/6
noviembre 2019
Ø562
Nº LED
WEIGHT
14Kg
12 LED
15Kg
24 LED
17Kg
32 LED
16Kg
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
WARNING
BEFORE STARTING THE INSTALLATION OF THIS PRODUCT,
PLEASE READ CAREFULLY THE FOLLOWING INSTRUCTIONS
AND KEEP THERE IN A SAFE PLACE.
THE INSTALLATION MUST BE CARRIED OUT BY QUALIFIED
STAFF.
IMPROPER HANDLING OF COMPONENTS OR THE OWN
FIXTURE ITSELF MAY DAMAGE THE PROPER OPERATION OF
THIS PRODUCT, CONSEQUENTIALLY THE MANUFACTURER'S
WARRANTY WILL BE VOID.
MANUFACTURER'S WARRANTY WILL BE VOID AUTOMATI-
CALLY IF THE INSTALLATION DOES NOT FOLLOW THE INDI-
CATIONS OF THE REBT 2002.
IT IS MANDATORY TO APPLY THE REBT ITC BT09-4 (INS-
TALLATION OF THE SURGE PROTECTOR IN LINES AND
LIGHTING FIXTURES) FOR INDUSTRIAL FACILITIES AND
PUBLIC LIGHTING. THE WARRANTY DOES NOT COVER DA-
MAGES CAUSED BY OVER-VOLTAGE IN LIGHTING WITHOUT
SURGE PROTECTOR.
OBSERVE
PRECAUTIONS
HANDLING
SENSITIVE COMPONENTS (LED).
DEGREE OF PROTECTION
Degree of waterlightness
Module impact resistance
INSTALLATION
Maximum surface wind exposed
Maximum. Height of installation
FOR
ELECTROSTATIC
IP66
IK08
0,50m
2
Until 14m
Publicidad
Tabla de contenido
