Mainstays MS17-D4-1011-03 Manual De Instrucciones página 15

Assembly Instructions for Table-top Display
Tools required: hex wrench (provided), Phillips screwdriver, mallet, power drill, and 3/8" drill bit.
19. Position the assembled unit at the desired location against a wall. If necessary, adjust the
pre-attached Floor Levelers at the bottom of the Legs (E) to level the unit. Now, follow the
instructions printed on the plastic bag containing the Tipping Restraint Hardware to attach the
tip-over restraint to the spine and the wall.
NOTE: Young children can be seriously injured by tipping furniture. You must install the
Tipping Restraint Hardware with the unit to prevent any accidents or damage to the unit. The
tipping restraint is intended only as a deterrent, they are not a substitute for proper adult
supervision. The tipping restraint is not an earthquake restraint. If you wish to add the extra
security of earthquake restraints, they must be purchased and installed separately.
20. The table-top console is now ready for use. Be sure to position your Flat Panel TV in the
center of the console.
NOTE: If you choose the Wall Mounted configuration, proceed to PAGE 22.
E
15
E
E