Nice neostar A Manual De Instrucciones página 3

NEOSTAR_A
The motor's electrical "up" and "down" phases are perfectly interchangeable, since the former causes the motor to rotate in one direction,
the latter in the opposite direction. The up and down movements are determined by the side from which the motor is inserted in the wind-
ing tube. To change the direction of rotation, switch the brown and black conductors.
Except for the limit switch programming operations, it is possible to connect multiple NEOSTAR motors in parallel so as to
utilise a single reverser switch.
2.2) Connector and power supply cable
nel only).
!
WARNING: if the power cord is damaged it must be replaced with an identical type supplied by the manufacturer or
an authorised service centre.
If it is necessary to disconnect the motor from the power supply cable proceed as shown in the figures below:
Rotate the ring nut until the
chamfer matches one of the
latch-on teeth, then release it.
3) Adjustments
The NEOSTAR series tubular motors are equipped with an electron-
ic limit switch that interrupts the power supply when the awning or
shutter reaches the opening or closing limit. These two limits must
be programmed into the memory after the motor has been installed
and the shutter/awning mounted. The motor can still be command-
ed even if these two travel limits, (hereinafter referred to as "position
0" and "position 1") have not yet been memorised; however, the
Brown = electrical UP phase
Black = electrical DOWN phase
Blue = Common
Yellow/Green = Earth
(this chapter relates only to the NEOSTAR MA version and concerns service person-
Repeat the operation for the oth-
er tooth.
Position 0
Bend the cable inward and
remove the protection by rotating
it gently outward.
movement in this case will be interrupted twice, momentarily, at the
start of each manoeuvre, and will then continue unimpeded and
uncontrolled. If only one travel limit has been memorized, the move-
ment will be interrupted only once, momentarily, at the start of each
manoeuvre, and will then continue unimpeded and uncontrolled.
Position 1
TTU
Pull out the connector.
GB
3