About This Document; General Safety Precautions - STEINEL PROFESSIONAL HF 3360 KNX Información

GB
1� About this document
– Please read carefully and keep in a safe place.
– Under copyright. Reproduction either in whole or in part only with our consent.
– Subject to change in the interest of technical progress.
Symbols
!
Hazard warning!
Reference to other information in the document�
...
2� General safety precautions
!
Disconnect the power supply before attempting any work on the sensor�
• This product must only be installed by a qualified electrician in accordance with
national wiring regulations as defined in VDE 08 29 (DIN EN 5000 90).
• Installed improperly, low-voltage products can cause extremely serious personal
injury or damage to property.
• This product must never be connected to a 230 V AC power supply as it is intend-
ed for connection to an extra-low voltage power supply.
• Only use genuine replacement parts.
• Repairs may only be made by specialist workshops.
3� HF 3360 KNX
Proper use
– Sensor suitable for indoor wall and ceiling-mounting
The Sensor is suitable for switching on a light automatically. The unit is not suitable
for burglar alarm systems as it is not tamperproof in the manner prescribed for such
systems.
The HF 3360 KNX is an active motion detector. It responds to the slightest movement
regardless of temperature. The integrated HF sensor emits high-frequency elec-
tromagnetic waves (5.8 GHz) and receives their echo. In response to the slightest
movement in the detection zone, the change in echo is perceived by the sensor.
A microprocessor then issues the switch command "switch light ON". Detection is
possible through doors, panes of glass or thin walls.
18
Optionally, all function settings can be made via the RC6, RC7 remote controls as
well as the Smart Remote. (➔ 7� Accessories)
Package contents for surface-mounted installation (Fig� 3�1)
Package contents for concealed installation (Fig� 3�2)
Product components (Fig� 3�3)
A Status LED
B Programming button
C Load module, power supply lead, surface-mounted
D Load module, power supply lead, concealed
E Designer trim, round or square
F Sensor module
Product dimensions
Ceiling / wall mounting, surface-mounted and concealed wiring (Fig� 3�4)
4� Installation
Wiring diagram (Fig� 4�1)
An optional corner wall mount is available for mounting the HF 3360 KNX.
(Prod. no. 035174 white)
– Surface-mounted installation
If the rubber seal is damaged, the cable entry openings must be sealed with an M16
or M20 (at least IP54) double seal cable gland.
For mounting on the wall, a condensation water drainage hole (Ø 5 mm drill bit) is
marked next to the rubber seal. This must be opened if necessary. (Fig� 5�4)
5� Mounting
• Check all components for damage.
• Do not use the product if it is damaged.
Installation procedure
Wall-mounting, concealed power supply lead (Fig� 5�1)
Ceiling mounting, concealed power supply lead (Fig� 5�2)
Ceiling mounting, surface-mounted power supply lead (Fig� 5�3)
Wall-mounting, surface-mounted power supply lead (Fig� 5�4)
19