Regeneration Cycle; Switching Off The Machine; Cleaning The Machine At The End Of The Day - ASBER G-OEM-500 Instrucciones De Instalación, Uso Y Mantenimiento

EN
5.1.10.2 Drainage using the drainage pump (optional)
The drainage using the drainage pump option is only available on request. The drainage pipe must
always be fitted on a siphon to prevent the return of odours.
In G (Fig.9) model machine, proceed with the draining as follows:

Remove the overflow valve.

Select the drainage function on the selector switch (I).

Close the door and press the start cycle button (D), the drainage cycle will start automatically.

At the end of the cycle (approx. 160 s), replace the overflow valve. The machine may be
switched off.
In GM (Fig. 10) and GT (Fig.11) models, proceed as follows:

Remove the overflow valve.

Open the door and press the button M for 3 seconds and the drainage cycle will start
automatically

At the end of the cycle (approx. 160 s), replace the overflow valve. The machine may be
switched off.
To drain the machine with the drainage pump, the hose must be at a
height (max. 680 mm).

5.1.11 Regeneration cycle

In the GM (Fig.10) and GT (Fig.11) models, the dishwasher is fitted with a manual regeneration or
descaling system for water with a hardness equal to or greater than 10 °fH. This means that the
water entering the machine must be softened. If this system is not fitted, the machine pipes may
become blocked due to the build-up of too much limescale.
To ensure that the system operates correctly, proceed as follows:

Open the door.

Remove the overflow and wait for the tank to drain.

When the tank has drained and with the door open, select the regeneration cycle by
pressing N for 3 seconds until the pilot light stays on.

Close the door and the regeneration cycle starts, the pilot light stays on and flashing until
the end of the cycle.

After approximately 20 minutes, the pilot light goes out indicating that the regeneration
cycle has finished.

When the regeneration cycle has finished, open the door and mount the overflow in place.

Close the door and the machine will start to fill the tank as it is empty.

Fill the tank with salt every week, closing the cap correctly.
The appearance of streaks of lime on the clean dishes is an indication of
the need to urgently run the descaling or regeneration cycle.
It is recommended to clean the inside of the machine once the
regeneration cycle has been completed.

5.1.12 Switching off the machine

In the G (Fig.9) models, to switch off the machine, turn the selector (A) to 0.
In the GM (Fig.10) and GT (Fig.11) models, the dishwasher is switched off by pressing the ON/OFF
(J) button for 1.5 seconds.
The machine should not be switched off during the wash process as this will stop the tableware inside
the machine from being cleaned properly.

5.1.13 Cleaning the machine at the end of the day

At the end of the day, the filters, wash distributors, rinse branches and other accessories must be
cleaned. This is necessary to prolong the service life of the machine. To ensure the efficient washing
of the dishes, the dishwasher must be perfectly clean and disinfected.
51