Technical Data; Disposal Note - Grohe RAINSHOWER 310 SMARTCONNECT 26 640 Manual De Instrucciones

USA
Sources of interferences
The transceiver operates in the ISM-frequency range (2.4 GHz).
The installation in the vicinity of equipment with the same
channel occupancy (e.g. wireless devices, RF components,
etc. observe the manufacturer's documentation!]) should be
avoided.
Obstructions/barriers
For operation under adverse environments, in buildings /
rooms with reinforced concrete walls, steel and iron frames,
or near of obstructions (e.g. furniture) of metal, the radio
reception can be disturbed and interrupted.
Kind of obstructions
Wood, synthetic material
Water, brick, marble
Plaster, concrete, glass, solid wood
Metal

Technical data

• Radio frequency:
• Transmitter power:
• Battery Remote Control:
• Batteries head shower:
• Type of protection Remote Control:
Electrical test data
• Software class:
• Contamination class:
22
Interference or
shielding potential
Low
Medium
High
Very high
2,402 ... 2,483 GHz
< 10 mW
1x 3 V lithium battery
(type CR 2032)
3x AAA batteries
IP 57
A
2
22
Installation
After inserting the batteries the pairing mode is active for
5 minutes.
When paired, the LED stops flashing.
Installation of the head shower
When installing e.g. on plasterboard walls (not solid walls) it
must be assured that an appropriate reinforcement is in place
to ensure sufficient strength.
Operation
By pressing a button for more than 3 seconds, this spray mode
is preset, see page 5.
Maintenance
Shower
The function of the SpeedClean nozzles is guaranteed for
a period of five years.
Battery
For battery replacement, see page 6 and 7.
Discharged batteries must be removed from the device
immediately.
Increased risk of leakage!
Note: No settings saved by the user will be lost when
changing the battery or if the battery discharges.

Disposal note

This category of device does not belong in the domestic
waste, but must be disposed of separately in accordance
with the relevant national regulations.