KROM Khensu Guía Rápida De Instalación página 4

INSTALLATION
1) Plug Krom Khensu's receiver into one of your device's USB ports.
2) Turn on your device.
3) Press MODE button during 15 seconds, the 4 LEDs will rapidly flash.
4) When one of the four LEDs stays lit, the gamepad is paired successfully.
CONFIGURATION MODES ( X-INPUT / D-INPUT )
1) Default mode is X-input (LED under TURBO button is off and 1ST LED is lit)
2) To turn it to D-input mode: Hold the MODE button for 5 seconds, LED under TURBO button
will turn on.
Be sure to set the game controller to the correct mode before starting the game. If you
switch during game play it could lead to the game not identifying the controller. If this
happens, restart the game.
FUNCTIONS
¬ The controller switch to sleep mode after 5 minutes in standby.
Press MODE button to switch from standby to working mode.
¬ When the battery controller is low, LED indicator will flash, you should connect
the USB cable to continue enjoying your game.
¬ To change the function between the left joystick and D-pad, press MODE button:
1ST LED will turn off and the change will take place.
¬ TURBO SETTING: Hold down the button which you want to set into turbo mode, then press
TURBO key one time. Turbo function is now set. Hold the key which you have set as turbo
function, then press TURBO button to clear the turbo mode.
¬ RESET: To return to the factory settings, press the RESET button located on the back of
the gamepad.