BGS technic 9465 Manual De Instrucciones página 4

USE
1. Insert the spindle (2) into the clamping nut of the spreading claw puller (5).
2. Install the support feet (1) to the support bridge (4).
3. Insert spreading claw puller (5) into cylinder liner (D).
4. Slide the spindle (2) into the center hole of the support bridge (4).
5. Align support feet (1) and place it onto the cylinder block.
6. The newly spreading system will position all three jaws (A) quickly and safely beneath the edge
(A) of the cylinder liner (D) by turning the spindle.
7. Install the spindle nut, check all components for correct seat and pull out the cylinder liner (D)
by tightening the spindle nut.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tool
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Cylinder Liner
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed