Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.1 Programming Mode Parameter List
Note :
,
and
( 0/2..10V or 0/4..20mA ) is selected.
Temperature Sensor Scale Selection Parameter ( Default = 0 )
Analogue (T
Temperature
It can be adjusted from -1999 to (
If
If
Temperature
It can be adjusted from (
According to the device type10V
Note :
,
Temperature Control Selection Parameter On/Off or PID ( Default = 0 )
Note: If this parameter is select 0, PID parameters (
If this parameter select 1,
Self Tune (Step Response Tuning)
PID - Proportional Control Parameter
This parameter value can be adjusted form 0.1 to 100.0
PID - Integral
This parameter value can be adjusted form 0 to 3600.
PID - Derivative Parameter
This parameter value can be adjusted form 0 to 999.9
PID -Period Time Parameter
This parameter value can be adjusted form 1 to 150 second.
PID -Temperature Protection Parameter
When PID operation is performed, the heating output is switched off if the
temperature value goes above the value defined by
0.0, if the value decrease button is pressed,
disabled.From 1 to 10°C for NTC,PTC, PT-100 (0°C, 100°C) ,From 1 to 18°F for
NTC,PTC ,PT-100 (32°F, 212°F),From 0.1 to 10.0°C for NTC, PTC, PT-100
(0.0°C,100.0°C), From 0.1 to 18.0°F for NTC, PTC, PT-100 (32.0°F,212.0°F) ,From
1 to 10°C for ProNem Mini PMI-P (-20°C, 80°C) ,From 1 to 18°F for ProNem Mini
PMI-P (-4°F,176°F), From 0.1 to 10.0°C for ProNem Mini PMI-P (-20.0°C,80.0°C),
From 0.1 to 18.0°F for ProNem Mini PMI-P (-4.0°F,176.0°F).
parameters are shown, if the Temperature sensor
emperature)
input range is determined with this parameter.
(1)
Z
0..10V
veya 0..20mA
(1)
Z
2..10V
veya 4..20mA
Sensor Scale Low Limit Parameter : ( Default = 0 )
=0, according to the device type 0V
=1, according to the device type 2V
Sensor Scale High Limit Parameter : ( Default = 100 )
parameters are shown, if the Temperature sensor analogue input type is selected .
On - Off selected.
PID selected.
parameter will be not observed.
Device does not do (
Device does operation.
Parameter( Default = 300 )
(2)
Z
(2)
Z
-1). At this value analogue input becomes;
(1)
Z
Z
(1)
+1) to 9999. At this value analogue input becomes;
(1)
(2)
Z
Z
or
20mA
,
,
Selection Parameter ( Default =
Step Response Tuning
( Default =1.0 )
( Default = 60 )
( Default = 1 )
( Default =
appears and this function is
analogue
(2)
Z
or
0mA
(2)
Z
or
4mA
,
,
) will be not observed.
) operation.
)
. When the value is 0 or
input type
)
9
Publicidad
Tabla de contenido
