Kohler K-2283 Guia De Instalacion página 4

Hanger
Bolts
10-7/8"
(27.6 cm)
Mark anchoring holes.
Screw
Washer
8-3/4"
(22.2 cm)
2. Install the Lavatory
Apply two self-adhesive pads to each of the three ribs on the
underside of the lavatory basin.
Carefully lift the lavatory into place on the pedestal, and slowly
move the pedestal as required to ensure proper fit in the desired
location.
NOTE: The lavatory must be supported by the pedestal.
Verify the lavatory is level and flush against the finished wall.
Adjust or add self-adhesive pads as needed.
Locate the two lavatory anchoring holes and mark the hole
locations on the finished wall. Now mark the floor through the
hole in the pedestal bottom.
Carefully remove the lavatory from the pedestal. Then move the
pedestal from the area.
Drill 1/4" mounting holes at the marked locations on the finished
wall and the floor.
NOTE: You can also use other fastening devices of sufficient size
and strength.
Install the hanger bolts to the backing material so they extend
1-3/8" (3.5 cm) between the cap nut and the finished wall.
Install the faucet and drain to the lavatory according to the
manufacturer's instructions.
1014178-2-E
Finished
Wall
Faucet
Washer
Cap Nut
Underside of Basin
Pedestal
Pads
Mark floor
here.
4 Kohler Co.