Important Safeguards - Kalorik FE 40764 Manual De Instrucciones

Fax +1 305 430 9692

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should
always be followed, including the following:
1. READ ALL INSTRUCTIONS
2. Check that voltage in your home corresponds to that stated on
the rating plate of the appliance, before using the appliance.
3. To protect against electrical shock do not immerse cord, plug, or
the motor unit in water or other liquid.
4. Close supervision is necessary when the appliance is used by or
near children.
5. Please keep out of reach of children and pets. This product is not
intended for use by children, by persons with reduced physical,
sensory or mental capabilities, or lacking experience or
knowledge, unless they have been given supervision or instruction
concerning the use of the product, by a person responsible for
their safety. Extra caution is always necessary when using this
product.
6. Unplug from outlet when not in use and before putting on or
taking off parts, and before cleaning.
7. Avoid contact with moving parts.
8. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions or has been damaged in any
manner. Return appliance to the nearest authorized service
facility for examination, repair, or adjustment.
9. The use of accessory attachments not recommended by the
appliance manufacturer may cause fire, electric shock or injuries.
10. Do not use outdoors.
11. Do not let cord hang over edge of table or counter or touch hot
surfaces.
12. Do not place on or near a hot gas or electric burner, or in a
heated oven.
13. Switch off the appliance before changing the accessories or
approaching parts which move in use.
14. To disconnect remove the plug from the wall outlet.
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
2
Assembly page 2/40
special instruction from Team
FE 40764 - 120501