Assembly And Use - Kalorik FE 40764 Manual De Instrucciones

Fax +1 305 430 9692
1. Pusher
2. Lid with feeding tube
3. Auger
4. Filter (sieve)
5. Strainer holder
6. Strainer housing
7. Pulp spout
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the
requested breaks. Failure to follow this instruction carefully may result
in damage to the motor. The maximum continuous usage time is 30
minutes. After this, please rest your appliance for around 2 hours.
BEFORE THE FIRST USE
Carefully clean the outer housing with a damp cloth, wash the
accessories in warm soapy water and dry with a dry towel. Do not
use abrasive cleaners. Do not immerse the power cord or motor unit
in water or any other liquid.
Note: This appliance is equipped with a safety switch; therefore you
can only switch on the appliance when the motor unit and the
accessories have been assembled correctly.

ASSEMBLY AND USE

Note: Before assembling the appliance, make sure that it is not
plugged in.
Put the motor unit on a table or a flat surface.
•
On the bottom of the strainer housing there is a silicone seal (Fig.
•
1), which closes the pulp outlet from inside. To clean the pulp
outlet, remove the silicone seal and put it back after cleaning.
Always make sure the seal is closed before using the appliance.
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
8. Juice spout
9. Safety switch
10. Main base
11. Switch button
12. Juice container (Transparent)
13. Pulp container (Black)
14. Cleaning brush
6
Assembly page 6/40
special instruction from Team
FE 40764 - 120501