Wiring Connection; Contents; Installation - GAPOSA QCWS Manual De Instrucciones

ENGLISH
12
> CONTENTS
Wireless climatic sensor 868.30MHz which controls radio motor/s for awnings, vertical blinds and outdoor
venetian blinds, according to weather conditions under stated thresholds.
IMPORTANT: this sensor does not protect the awnings/blinds against strong gusts of wind. When weather
conditions presents this sort of risk, ensure that the awning/blind remains closed.
> INSTALLATION
Note: ensure that sensors are not installed close to metal surfaces, panes of metalised glass or generally
magnetic fields can reduce the radio signals range.
Radio devices working on the same frequency could interfere with signals reception.
Select the right place for the installation of the sensor. Be careful that trees, roofs or parts of the building do
not affect the light intensity and wind measurement.
The adjustable base of the sensor allows the right installation (horizontal position) on any surface.
> WIRING CONNECTION
1. Open the top cover by the 4 screws on the bottom.
2. Connect the power line as described below.
Check that the power supply corresponds to the label data.
3. Close the top cover and tight the screw to seal it.
230 V~ / 50 Hz
120 V~ / 60 Hz
Power supply
Additional Accessories required:
2-wire cable that meets the standards of the country in which it is installed