Tecnowind KA4020L Manual De Instrucciones página 37

Procedure for fixing

Dimensional drawings

Possible methods:
in case of ceiling fixing (holes A
in case of fixing by means of springs (B

Set the hood by tightening the bracket as needed
Connecting and fitting
Before connecting the appliance, check the household installation.
Appliance with prefitted power cable:
trained after-sales engineer.
Installing: Do not trap the power cable and do not route it over sharp edges. If the
oven is a built-under type, route the cable on the rear corners of the oven to the
socket.
Electrical Connection
Connect the device to the mains and check the operation.

voltage, see the rating plate .
INSTALLATION
I IV
-A )
I
-B
The power cable must only be replaced by a
EN/1
IV
)