Ashley Yandel Power Lift Manual De Instrucciones página 4

Figure B
6. If your model has back wings, align the male the female brackets and slide the wing down into place, See Figure C
Figure C
7 . Connect the Power Transformer cable to the corresponding plug coming from the back of the chair Figure A #5
8 . Connect the Power Cord into the Power Transformer Figure A #6
9 . Connect the power cord into an electrical outlet near where the chair will be used Figure A #7.
Clear area below chair before lowering to reduce risk of injury or death.
WARNING:
The power bu�on is intended to allow you to disable the chair func�ons.
To stop the chair from func�oning using the power bu�on, press the Power Bu�on so the LED light is off.
If the chair is not func�oning, check the plug in and connec�on of the cords first (The order is A-B-C-D), see the Figure A. If all connec�ons
are good, verify the LED is lit on the power bu�on. See illustra�on on bo�om of page
Figure A.
Be sure cords are clear from the chair prior to opera�on.
May,2019
Page 4 Of 14
SIGNATURE DESIGN BY ASHLEY® All Rights Reserved.