Volume Control - Glass 1989 NonSoloDoccia Home Manual De Instalación - Uso - Mantenimiento

The monoclimate steam function can be activate by pressing the
on/off button (1).
The steam bath has a pre-set time of approximately 90 minutes.
To interrupt the steam function before its end press again the on/
off button (1).
At the end of the cycle the led fl ashing. Now rinse cycle and
emptying of boiler starts.
STEAM DIFFUSERS FUNCTIONING.
• It is possible to fi t some cotton dipped in aromatic products
inside the steam diff user. Make sure that the cotton does not
clog the diff user head.
• Use the steam bath for short periods, especially when used the
fi rst times. The time can then be gradually increased but always
with attention to general physical conditions.
• At the end of the steam bath it is advisable to rinse yourself
under a lukewarm shower, then dry yourself, massaging your
body vigorously. It is advisable to apply a moisturising cream
to skin.
• Before and after a steam bath, it is advisable to drink water,
fruit juices or salt integrators.
The steam outlet nozzle becomes very hot when using the
steam function!
Hot water come out of the dispenser during the steam cycle.
Do not touch the steam dispenser when it is in use or right after
turning it off .
CHROMOTHERAPY
To start the chromotherapy function, just press the button (2); the
preset duration is approximately 60 minutes.
The fi rst time the button is pressed the WHITE LIGHT mode
switched on.
The second time the button is pressed the chromotherapy pre-set
cycle is switched on.
The third time the button is pressed, during the pre-set cycle, the
required colour be selected.
Just press the same key again to turn off the chromotherapy.
BLUETOOTH
Bluetooth allows several devices enabled with the function to
communicate with each other within a radius of some tens of
metres.
Before you can use this function, the transmitter (MP3 players,
mobile phones, PCs and other players with Bluetooth
be connected to the Bluetooth receiver in the product.
PAIRING OF DEVICES
To search for other devices, do a scan with the transmitter (see
transmitter guide). The presence of a Bluetooth receiver will be
displayed with the word "GLASS 1989".
Select the "GLASS 1989" device and proceed with the pairing.
After the pairing the "GLASS 1989" device will be saved in the
"paired devices" list.
Now you can start an audio track through the transmitter PLAYER.
NOTE: the Bluetooth "GLASS 1989" may not be compatible
with all the functions enabled on your Bluetooth transmitter, e.g.
functions of track progress, volume control, etc. For more details,
consult the user's guide of your device.

VOLUME CONTROL

The volume is controlled from the transmitter (MP3 readers,
mobile phones, PCs...) if enabled with this function.
2.1) must
®
17
EN