Axxess TYTO-02 Instrucciones De Instalación página 3

Connections to be made
From the 10-pin harness, to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the orange wire to the illumination wire.
Note: If the aftermarket radio does not have an illumination wire, tape up and
disregard the orange wire.
• Connect the 14-pin harness to the TYTO-02.
From the 28-pin harness, to the aftermarket radio:
• Connect the Green/Purple wire to the reverse wire.
• Connect the White and Red RCA to the audio AUX in to retain the OE 3.5mm
jack (if equipped).
TYTO-02
Installing the TYTO-02
• With all connections completed to the aftermarket radio, plug the 28-pin and
10-pin harness into the vehicles wiring harness.
• Reconnect the negative battery terminal.
• Cycle the key, by turning the ignition on for 30 seconds. Then off and on again
to test the radio.
Testing the TYTO-02
• Turn the ignition on if not already, and then turn the radio on to verify that the
radio works. Check balance and fader controls for proper operation.
• To adjust the overall volume of your audio system, rotate the potentiometer
which is located on the 16-pin side of the interface clockwise.
Additional 12-pin harness
• This 12-pin harness is to be used along with the ASWC-1
(sold separately) to retain steering wheel controls. Please refer to ASWC-1
instructions for programming.
3
(ASWC-1 pre-wired harness)