Replacing No. 764 Cutter Wheel; Replacing Jaw Inserts; V-Belt Tension/Replacement - RIDGID 1224 Manual De Instrucciones

Ocultar thumbs Ver también para 1224:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1224 Threading Machine
Replace thread cutting oil when it becomes dirty or con-
taminated. To drain the oil, position a container under
drain plug at end of reservoir and remove plug. Clean
build up from the bottom of the reservoir. Use RIDGID
Thread Cutting Oil for high quality threads and maxi-
mum die life. Reservoir in the base will hold approxi-
mately 5 qt (4,7 l) of thread cutting oil.
The oil pump should self-prime if the system is clean. If it
does not, this indicates that the pump is worn and should
be serviced. Do not attempt to prime the pump.

Replacing No. 764 Cutter Wheel

If the cutter wheel becomes dull or broken, push cutter
wheel pin out of frame and check for wear. If needed
replace pin, and install new Cutter Wheel (see RIDGID
catalog). Lubricate pin with light lubricating oil.

Replacing Jaw Inserts

If Jaw inserts are worn out and do not grip pipe, they need
to be replaced.
1. Place screwdriver in insert slot and turn 90 degrees in
either direction. Remove insert (Figure 31).
Screw Driver
Insert
To Remove
Figure 31 – Replacing Jaw Inserts
2. Place insert sideways on locking pin and press down
as far as possible (Figure 31).
3. Hold insert down firmly, and with screwdriver, turn so
teeth face up.

V-Belt Tension/Replacement

When lubricating the grease fittings, check v-belt ten-
sion. Apply moderate finger force (about 4 pounds (2
kg)) to the midpoint of the belt. Belt should deflect approx-
imately
1
/
" (3mm) (Figure 32).
8
1. Loosen setscrew and
bracket to the rail.
2. Loosen the
1
/
" screw that retains the belt tensioner
4
and pull the belt tensioner back.
18
PRESS
DOWN
Locking
Teeth
Pin
To Replace
5
/
" nut that lock the motor
16
3. If changing the belt, loosen the four fasteners that hold
the motor to the motor bracket and slide the motor
towards the pulley. Remove and replace belt. Slide
motor away from pulley and secure fasteners that
hold motor to bracket.
4. Push the belt tensioner forward until belt is properly
tensioned. Tighten
1
/
" screw.
4
5. Secure setscrew and
bracket to the rail.
Belt
Tensioner
Set Screw
& Nut
Figure 32 – Motor Bracket and Belt Tensioner
5
/
" nut that lock the motor
16
Motor
Bracket
Rail
940-713-030.10_REV. G

Publicidad

Tabla de contenido
loading

Tabla de contenido