Publicidad
Idiomas disponibles
Idiomas disponibles
Step 5 – Preparing Documents for Processing
To improve document throughput and scanning, it is recommended
that the operator perform the following document preparation steps
prior to loading documents into the scanner:
•
Remove all staples, paper clips and rubber bands
•
Straighten any bent corners, folds, creases or curls
Step 6 – Prior to Inserting Documents into the Scanner
To insure proper document feeding, it is recommended that the
Operator perform the following steps prior to loading
documents into the scanner input hopper:
1. All documents are facing the correct direction
2. Align the leading and bottom edges of all of the documents
8227 4738-003 January 2017
SmartSource Elite – Setup and Operation
Leading
Edges
Aligned
Bottom Edges Aligned
© 2017 Digital Check Corp.
Step 7 – Inserting Documents into the Scanner
•
Place documents into the feeder bay, aligning the bottom edges
of the documents with the feeder bay floor
•
Align the leading edges of the documents with the check graphic
located on the top cover (as shown)
•
Align ID cards with the bottom surface of the ledge (as shown)
Front Entry – Check Insertion
Step 8 – Scanner Operation
Use of the SmartSource Elite requires application software. Please
contact your IT department or solution provider for assistance with
the installation and use of any required check processing software.
Step 9 – Clearing Document Stops
Rear Entry – ID Card Insertion
Methods to clear documents from the
track:
1. Hold power button down for 1
second and release
2. Pull documents out of the scanner
in the direction shown
CAUTION: Do not pull documents out
straight up.
Page 2 of 16
Publicidad
