About Safety; About Your Pool And Filter System; Pre-Installation Check List - AquaTools AT5800 El Manual Del Propietario

Please read the following before installing
This is the safety alert symbol. When you see this
symbol on your system or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury.
warns about hazards that will cause
death, serious personal injury, or major property dam-
age if ignored.
warns about hazards that can cause
death, serious personal injury, or major property dam-
age if ignored.
warns about hazards that will or can
cause minor personal injury or property damage if
ignored.
Carefully read and follow all safety instructions in this
manual and on equipment. Keep safety labels in good
condition; replace if missing or damaged.

ABOUT YOUR POOL AND FILTER SYSTEM:

Before installing your cleaner, review and
understand all warnings and safety informa-
tion on the inside front cover of this manual.

Pre-installation check list

Before installing the cleaner in a vinyl liner pool:
Check liner closely for signs of deterioration or damage
from age, chemicals, pool wall damage, etc. If any damage
is found, have a qualified pool professional make all neces-
sary repairs. Also, if there are stones, roots, etc., under the
liner, remove them before installing the cleaner.
Before installing the cleaner in a gunite pool or a pool
that is partially or completely tiled:
Repair loose tiles and tighten any loose light rings.
Before installing the cleaner, clean your filter system:
Make sure you have cleaned the filter, including back-
washing, rinsing, and emptying all baskets. A clean system
is necessary for proper cleaner operation and coverage.
your new automatic pool cleaner!

ABOUT SAFETY:

1058 0594
Before installing the cleaner, fill the hose with water:
Always make sure the cleaner head is submerged and
the hose is full of water before connecting the hose to
the filtration system (whether through a skimmer or dedi-
cated wall fitting). Air in the system can damage the
pump through dry running and overheating.
Before installing the cleaner, understand cleaner coverage:
The cleaner is designed to rid your pool of debris in
approximately 4-6 hours. Less time could be needed,
depending on the pool size.
The cleaner was not designed to automatically clean
steps or swimouts or to work under a solar cover. It was
also not designed to do initial cleanup for a new pool or
when opening your pool for the season.
Suction entrapment, injury, and drown-
ing hazard. If your pool has a dedicated suction
port ("vac port") for vacuuming or for an automatic
pool cleaner, it must be covered when not in use.
A spring loaded safety cover is included with your
cleaner. Install it on the suction port to prevent
entrapment and injury.
2
Hazardous suction.
Can trap and tear
hair or body parts.
Can cause drowning.
Do not play with cleaner
or hose or apply to body.
Do not let children use or
play with pool cleaner.
Stop pump before
attempting to clean unit.
Oscillator may
injure hands or fingers.
Stop pump before attempt-
ing to clean out pool cleaner
head.
Hose can trip
or entangle swimmers.
Do not allow swimmers in
pool while pool cleaner is
operating.