1. Remove existing food and accessories baskets,unplug
the appliance from the mains power and leave the doors open.
Ventilate the room thoroughly to accelerate the thawing process.
2. When defrosting is completed, clean your freezer as described
above.
Caution!
Don't use sharp objects to remove frost from the freezer. Only after
the interior completely dry should the appliance be switched back
on and plugged back into the mains socket.
Door seals cleaning
Take care to keep door seals clean. Sticky food and drinks can
cause seals to stick to the cabinet and tear when you open the
door. Wash seal with a mild detergent and warm water.
Rinse and dry it thoroughly after cleaning.
Caution! Only after the door seals are completely dry should the
appliance be powered on.
Replacing the LED light
Warning: The LED light must not be replaced by the user! If
the LED light is damaged, contact the customer helpline
for assistance. To replace the LED light, the below steps can be
followed:
1.
Unplug your appliance.
2.
Remove light cover by pushing up and out.
3.
Hold the LED cover with one hand and pull it with
the other hand while pressing the connector latch.
4.
Replace LED light and snap it correctly in place.
-16-