Midland G10 Manual De Usuario página 81

and/or has not been
en connected or installed Inspect the connections of the battery-charger and the
elded.
been selected.
ed area or is too far from
ng with
essive and/or there are
th
e channel
close to equipment that
computers, etc.)
Midland G10 instruction guide
Solution
Verify that the battery pack is charged and that it has
been correctly installed.
Recharge the battery pack.
installation of the batteries.
Move to an another area.
Adjust the volume level.
Check that the CTCSS tone or DCS code corresponds to
the one set by the parties you are communicating with.
Select the same radio channel used by the parties you
are communicating with.
Move to another area.
Check that the CTCSS tone or DCS code corresponds to
the one set by the parties you are communicating with.
Try temporarily disabling the Squelch by means of the
Monitor feature.
Move closer to the party you are communicating with or
to another area.
Check the traffic on the radio channel by means of the
Monitor feature and select another channel if required.
Increase the distance between the radio and this
equipment.
Try reducing the transmission time and/or using a low
power.
| 11