Cequent Towing Products 75363 Instrucciones De Instalación

Vehicle Bumper
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75363F
Wrenches: 18mm, 7/8", T-25, T-27
Drill Bits: ½"
Note: Hitch installation can be made easier
with a "cutter" type drill bit.
1
Qty. (2) Carriage bolt ½" x 1 ¾"
2
Qty. (2) Block ¼" x 1" x 3"
1. Remove rear fascia as shown in figure 2:
a. Remove tail lights by removing 2 screws, each side, inside lift gate opening and carefully pulling tail light straight back.
b. Remove 2 screws, each side, which fasten fascia under tail light.
c. Remove 5 screws inside each wheel well.
d. Remove access panel from bottom of fascia and return to vehicle owner.
e. Remove 4 screws from bottom of fascia.
f. Carefully pull fascia straight back to remove.
2. Remove bumper by removing 4 bolts each side, which secure bumper to rear vehicle panel. Retain bolts for hitch/bumper installation.
3. Raise hitch and bumper into position as shown, sandwiching hitch between vehicle end panel and bumper. Before tightening, position hitch so that
center bracket contacts bottom surface of steel bumper as shown in figure 1.
4. Using hitch as a template, drill 2 holes into bumper thru holes in hitch center bracket.
Note: Hitch installation can be made easier with a "cutter" type drill bit.
5. Install carriage bolts and block thru holes in bumper (drilled in step 4) and down thru holes in hitch center bracket. Install lock washers and nuts.
6. Reinstall fascia.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2005, 2008, 2009 Cequent Towing Products
Installation Instructions
Volkswagen Touareg
Plastic Fascia
Existing
Bolt
8 Places
FIGURE 2
Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft.
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft.
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV3, SUV4
Vehicle
Bumper
Hitch Center
Bracket
FIGURE 1 FIGURE 1
3
Qty. (2) Lock washer ½"
4
Qty. (2) Hex nut ½"
Sheet 1 of 3 75363N
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
6000 (2 724 kg)
6000 (2 724 kg)
Vehicle End Panel
1-12-09
Form: F205 Rev A 5-6-05
75363
44530
82301
Max Tongue
WT (LB)
600 (272 kg)
600 (272 kg)
Rev. E