Graham Field Grafco GF-TX5 Manual De Operación página 14

LCD (Liquid Crystal Display)
The LCD displays timer (10, 20, 30, 40, 50, 60 minutes and © continuous),
function modes (B, C, M, MM, MR, SD), alternate mode, pulse width, pulse
rate, low battery, and patient compliance counter.
1. To check the LCD function, turn device ON and all the parameters will be
displayed for 1-2 seconds.
2. After 1-2 seconds, the LCD will go to previous operation parameters.
Changing the LCD Parameters
• To set the treatment parameters on the TENS device, the unit must be
in the UNLOCK position. If the device is in the LOCK position it, can be
unlocked by pressing the UP and DOWN buttons simultaneously for 2-3
seconds.
• To switch between the different treatment parameters, press the MODE
button.
• Once in the desired mode, press the UP , DOWN, or SET button until the
desired treatment parameter is obtained.
• Once all of the desired treatment settings are displayed, the unit may
be locked by pressing the UP and DOWN buttons simultaneously for 2-3
seconds while in the timer function.
14