PRODUCT SPECIFICATIONS
SPECIFICATIONS
Max. Flow Rate: 1.2 GPM (4.5 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Polished chrome, brushed nickel or matte black finish
ASSEMBLY INSTRUCTIONS
1.
Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
2.
Before installation, ensure that the
flange (1) is placed on the bottom of
the new faucet assembly (2). Place the
faucet assembly (2) through the
mounting hole in the sink. Secure the
faucet assembly (2) to the sink using
the washer (3) and nut (4) provided.
Optional escutcheon
3.
installation:
Before installation, remove the
flange. Align the hole in the gasket
(1) and deck plate (2) with the
mounting hole in the sink. Place the
faucet assembly (3) through the
deck plate (2) and mounting hole in
the sink. Secure the faucet assembly
(3) to the sink using the washer (4)
and nut (5) provided.
NOTE: If the sink is uneven, use
silicone under the gasket (1).
Connect water supply lines.
4.
Use 1/2" IPS faucet supply lines (1) or
use coupling nuts (2) (not supplied)
with ball-nose risers (3) (not included).
Before tightening the faucet connector
to the water supply, apply a second
wrench to the supply tube fitting. This
will prevent the supply tube from
moving or twisting when tightening the
faucet connector. Do not overtighten.
Turn water supply or shut-off valve
back on and check for leaks. If leaks
occur, gently tighten the faucet
connections.
NOTE: The hot side inlet tube is
indicated by a label.
1
2
2
1
3
4
3
3
2
1
4
5
4
1
2
3
Ceramic cartridges
Manufactured to include no more than 0.25% weighted average lead content
on wetted surfaces
Total weight of item: 2.84 lbs.
Pop-up drain instructions:
5.
Remove the bottom gasket (1) and
nut (2) from the top gasket (3) and
pop-up body (4). Attach these pieces
together by pushing the bottom
gasket (1) down into the top of the
nut (2) and twisting together.
6.
Insert the pop-up body (1) into the
sink. Ensure that the top gasket (2)
rests securely between the top of
the sink and the top of the pop-up
body (1).
7.
From underneath the sink, screw
the bottom gasket (1) and nut (2)
assembly onto the pop-up body
(3) by twisting clockwise until
secure.
Important: After installation is
8.
completed, remove aerator from
the faucet using a coin (1).
Turn on the water supply and
allow both hot and cold water to
run for at least one minute each.
This flushes away any debris that
could cause damage to internal
parts. While the water is running,
check for leaks. Turn off the water
and replace the aerator.
2
SPECIFICATIONS
5
6
7
8
1
www.homewerksww.com
3
4
1
2
2
1
3
1
2